Datalogic Magellan 9800i - USB OEM Interface Options

Enter/Exit Programming Mode
176 Magellan™ 9800i Scanner
USB OEM Interface Options
The OEM-USB interface offers specific control over interaction with certain devices. Options
for this feature are as follows:
• FULL host interface support — Accepts scanner and scale configuration host commands.
• Compatible with Magellan SL host interface suppor
t — Uses Magellan SL host interface
support.
• Ignore host interface configuration of scanner and
scale — Ignores all scanner and scale
configuration host commands.
NOTE
This feature applies only to the USB OEM interface.
For other IBM interfaces, refer to the feature,
IBM
Interface Options
, earlier in this section.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
055000(CR)
USB OEM Interface Options = Full Interface Support
055001(CR)
USB OEM Interface Options = Compatible with Magellan
SL Host Interface Support
DEFAULT
055007(CR)
USB OEM Interface Options = Ignore Host Interface
Configuration of Scanner and Scale