Datalogic Magellan 9800i - Global MID-Label ID

Enter/Exit Programming Mode
234 Magellan™ 9800i Scanner
Global Mid-Label ID
This feature specifies a global mid-label ID that is added between two bar codes for
transmission.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the
Set Global Mid-Label ID bar code below. You’ll need to cover any unused bar
codes on this and the facing page to ensure the scanner reads only the bar code you intend
to scan.
3. Scan the appropriate digits from the
Keypad in Appendix C that represent the desired
mid-label ID characters; entered as two hex pairs.
A table containing the ASCII Character
Set and their corresponding Hex Values is available in the inside back cover of this man-
ual. ASCII parameters must be input by scannin
g a pair of hexadecimal digits for each
character. Thus, to set a two-character value of AB, bar codes containing the digits ‘4’, ‘1’,
‘4’, and ‘2’ must be scanned. The selectable range for this option is any hex value from 00
to FF.
Complete the programming sequence by scanning the Enter/Exit Programming Mode bar code.
04C7(CR)
Set Global Mid-Label ID
DEFAULT
Default Label ID for this symbology is:
00 = No Global Mid-label ID