Datalogic Magellan 9800i User Manual

Enter/Exit Programming Mode
140 Magellan™ 9800i Scanner
Remote Display — Enable/Disable
The scanning-scale can be configured to operate with or without a Remote Display.
NOTE
Recalibration/recertification may be required when adding a Remote Dis-
play. Consult your local Weights and Measures authority.
If this feature is enabled the scanner w
ill expect that it is connected to a
Remote Display, and will indicate an error if one is not. See
Error Codes in
the
Problem Isolation section for more information.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
040300(CR)
Remote Display = Disable
040301(CR)
Remote Display = Enable
DEFAULT

Datalogic Magellan 9800i Specifications

General

Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Power consumption (typical)	12 W
Standard interfaces	RS-232
Connectivity technology	Wired
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Built-in display	No

Weight and Dimensions

Weight	- g