Datalogic Magellan 9800i - GS1 Databar; Databar Omnidirectional Enable

Enter/Exit Programming Mode
282 Magellan™ 9800i Scanner
GS1 DataBar
The symbology family, GS1 DataBar
TM
, was formerly known as Reduced Space Symbology
(RSS). For the purpose of simplicity, GS1 DataBar variants are listed in this manual as
“DataBar.”
DataBar Omnidirectional Enable
Enables/disables the ability of the scanner to decode DataBar Omnidirectional labels.
NOTE
This value-added feature is a factory-programmed option. Contact
your dealer for information about upgrading your system to include
this advanced capability.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode belo
w. You’ll need to cover any unused bar codes
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
DEFAULT
04D000(CR)
DataBar Omnidirectional = Disable
04D001(CR)
DataBar Omnidirectional = Enable