Enter/Exit Programming Mode
300
Magellan™ 9800i Scanner
Code 39 Length Control
This feature specifies whether variable-length or fixed-length decoding will be set for Code 39.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the barcodes below.
You’ll need to cover any unused barcodes on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
DEFAULT
Code 39 Length Control = Variable Length
Code 39 Length Control = Fixed Length
To Next Page
Loading...
