Datalogic Magellan 9800i User Manual

Enter/Exit Programming Mode
134 Magellan™ 9800i Scanner
Scale Stale Weight Timeout
This option specifies the amount of time that scale data is presented to the host before being dis-
carded.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code, Set Scale Stale Weight Timeout below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner reads only the bar
code y
ou intend to scan.
3. Scan the appropriate digits from the Keypad in Appendix C that represent the desired
time interval. The selectable range is 20-33 in 10ms incr
ements.
Scan the Enter/Exit Programming Mode bar code to exit Programming Mode.
0452(CR)
Set Scale Stale Weight Timeout
DEFAULT
Default setting for this feature is: 330 milliseconds

Datalogic Magellan 9800i Specifications

General

Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Power consumption (typical)	12 W
Standard interfaces	RS-232
Connectivity technology	Wired
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Built-in display	No

Weight and Dimensions

Weight	- g