Enter/Exit Programming Mode
346
Magellan™ 9800i Scanner
Code 93 Stitching
Enables/disables stitching for Code 93 labels. When parts of a Code 93 barcode are presented to
the scanner with this feature enabled, the barcode parts will be assembled by the scanner’s
software, and the data will be decoded if all barcode proofing requirements are met.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the barcodes below.
You’ll need to cover any unused barcodes on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
Code 93 Stitching = Disable
Code 93 Stitching = Enable
To Next Page
Loading...
