Datalogic Magellan 9800i - Number of Data Bits

Enter/Exit Programming Mode
180 Magellan™ 9800i Scanner
RS-232 Number of Data Bits
Specifies number of data bits required for sending and receiving data.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code below representing the desired Data Bit setting. You’ll need to cover any
u
nused bar codes on this and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
009B00(CR)
RS-232 Number of Data Bits = 7
009B01(CR)
RS-232 Number of Data Bits = 8
DEFAULT