Datalogic Magellan 9800i - Databar Omnidirectional Minimum Read

Enter/Exit Programming Mode
Product Reference Guide 285
DataBar Omnidirectional Minimum Read
This feature specifies the minimum number of consecutive DataBar Omnidirectional decodes
before is accepted as good read.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this
and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
DEFAULT
04D201(CR)
DataBar Omnidirectional Minimum Read = 1
04D202(CR)
DataBar Omnidirectional Minimum Read = 2
04D203(CR)
DataBar Omnidirectional Minimum Read = 3
04D204(CR)
DataBar Omnidirectional Minimum Read = 4