Datalogic Magellan 9800i - Databar Expanded 2 D Component Enable

Enter/Exit Programming Mode
288 Magellan™ 9800i Scanner
DataBar Expanded 2D Component Enable
When this feature is enabled, the software will not decode an DataBar Expanded barcode with a
2D component associated with it, and the 2D component will be discarded.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the barcodes below.
You’ll need to cover any unused barcodes on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
DEFAULT
04D700(CR)
DataBar Expanded 2D Component = Disable
04D701(CR)
DataBar Expanded 2D Component = Enable