Datalogic Magellan 9800i - Standard 2 of 5 Enable

Enter/Exit Programming Mode
Product Reference Guide 357
Standard 2 of 5 Enable
Enables/disables the ability of the scanner to decode Standard 2 of 5 labels.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused barcodes
on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
DEFAULT
049400(CR)
Standard 2 of 5 = Disable
049401(CR)
Standard 2 of 5 = Enable