Datalogic Magellan 9800i - Scale Diagnostics Mode

Enter/Exit Programming Mode
Product Reference Guide 133
Scale Diagnostics Mode
Use this feature to allow or disallow the ability of an operator to initiate the advanced feature,
scale diagnostics.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this
and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
049F00(CR)
Scale Diagnostics Mode = Disable
049F01(CR)
Scale Diagnostics Mode = Enable
DEFAULT