Datalogic Magellan 9800i - EAS Exception Button

Enter/Exit Programming Mode
Product Reference Guide 155
EAS Exception Button
This feature is for use in Coupled Mode
1
. When it is enabled, EAS deactivation can be
manually initiated by placing the item wi
th the EAS tag downstream
2
of the horizontal scan
window and pushing the EAS Exception Push Button.
NOTE
The scanner emits a clicking sound while in deactivation state.
Duration of deactivation state is determined by the feature, EAS Deactiva-
tion Duration — Manual.
Options are:
• DISABLE — EAS Exception Button is disabled.
• ENABLE ALWAYS —The EAS Exception Button is always enabled.
• ENABLE ONLY WHEN SCANNER ENABLED — The EAS Exception Button is
only a
vailable when the scanner is enabled and running.
NOTE
Statistics are collected each time the EAS Exception Button is used to deac-
tivate an EAS tag.
To set this feature:
1. Scan the Enter/Exit Programmin
g Mode bar code.
2. Scan your selection from the bar codes below
. You’ll need to cover any unused bar
codes on this and the facing page to ensure that the scanner reads only the bar code you
intend to scan.
Complete the programming sequence by scanning the Enter/Exit Programming Mode bar code.
058400(CR)
EAS Exception Button = Disabled
058401(CR)
EAS Exception Button = Enable Always
DEFAULT
058402(CR)
EAS Exception Button = Enable ONLY When Scanner
Enabled
1. See EAS Mode on page 148 for more information about Coupled Mode.
2. “Downstream” in this case is defined as being the downstream side of t
he scan window from the direction of product flow, or
scanning direction.