Enter/Exit Programming Mode
132
Magellan™ 9800i Scanner
Scale Enable
Use this feature to enable or disable scale operation.
NOTE
Recalibration/recertification may be required when adding scale function-
ality. Consult your local Weights and Measures authority.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
Scale = Disable
Scale = Enable
To Next Page
Loading...
