Datalogic Magellan 9800i - Single Cable RS-232 Use STX

Enter/Exit Programming Mode
206 Magellan™ 9800i Scanner
Single Cable RS-232 Use STX
Enables/disables the ability of the scanner to use STX.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
047F00(CR)
Single Cable RS-232 Use STX = Disable
047DF01(CR)
Single Cable RS-232 Use STX = Enable
DEFAULT