Datalogic Magellan 9800i - Micro QR Code Length 1, Length 2 Programming Instructions

Enter/Exit Programming Mode
384 Magellan™ 9800i Scanner
Micro QR Code Length 1, Length 2 Programming Instructions
If Micro QR Code Length Control is set to Fixed-Length decoding, this feature specifies Micro
QR Code first fixed length. If Micro QR Code Length Control is set to Variable-Length
decoding, this feature specifies the minimum label length.
NOTE
Length 1 is the minimum label length if in variable length mode, or
the first fixed length if in fixed length mode. Length 2 is the maxi-
mum label length if in variable length mode, or the second fixed
length if in
fixed length mode. Length includes the barcode's data
characters only. Any value > 3700 will be considered to be 3700.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the barcode,
Set Aztec Length 1 or Set Micro QR Code Length 2 below. You’ll need
to cover any unused barcodes on this and the facing page to ensure that the scanner reads
only th
e bar code you intend to scan.
3. Scan the appropriate digits from the
Keypad in Appendix C that represent the desired
label length. The selectable range for this option is 00
01 to 3700. Pad all numbers with
leading zeros to yield a four-digit entry (0001-3700).
4. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
Default setting for this feature = 0001
042B(CR)
Set Micro QR Code Length 1
042C(CR)
Set Micro QR Code Length 2
Default setting for this feature = 3700