Datalogic Magellan 9800i - Label ID Control

Enter/Exit Programming Mode
Product Reference Guide 227
Label ID Control
This feature specifies whether or not Label IDs are transmitted to the host and if so, whether to
attach them as a prefix or suffix.
Choices are:
•Disable
• Enable as a Prefix
• Enable as a Suffix
To select the option for Label ID Control:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the desired option from the bar codes be
low. You’ll need to cover any unused bar
codes on this and the facing page to ensure that the scanner reads only the bar code you
intend to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
020500(CR)
Label ID Control = Disable
020501(CR)
Label ID Control = Enable as a Prefix
DEFAULT
020502(CR)
Label ID Control = Enable as a Suffix