Enter/Exit Programming Mode
258
Magellan™ 9800i Scanner
EAN-8 Guard Substitution
This setting enables the scanner to substitute a guard pattern for even-parity 6 for EAN8/JAN8
labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
EAN-8 Guard Insertion = Disable
EAN-8 Guard Insertion = Enable
To Next Page
Loading...
