Datalogic Magellan 9800i User Manual

Product Reference Guide 411
Appendix E
Host Commands
Accepting Commands from an RS-232 Scanner Host
The scanner responds to the following RS-232 commands:
COMMAND ASCII HEX COMMENT
Enable Scanner
E 0x45
Disable Scanner
D 0x44
Reset Scanner
R 0x52
Not On File Indication
F 0x46 Long series of beeps
Beep Good Read Tone
B 0x42 Beeps if Good Read Beep is enabled
Force Good Read Tone
0x01 Beeps regardless of beep setting
Bel
0x07 Force Good Read Tone
Identification request
i 0x69
Returns long response
a
a. Call Tech Support for information.
Health request
h 0x68
Returns long response
a
Status request
s 0x73
Returns long response
a
If one of the above commands is received, the scanner will perform the steps indicated for
the command. Host commands for other interfaces is also available. Contact Tech Support
for more details.

Datalogic Magellan 9800i Specifications

General

Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Power consumption (typical)	12 W
Standard interfaces	RS-232
Connectivity technology	Wired
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Built-in display	No

Weight and Dimensions

Weight	- g