Datalogic Magellan 9800i - UPC-A Number System Character Transmission

Enter/Exit Programming Mode
238 Magellan™ 9800i Scanner
UPC-A Number System Character Transmission
Enables/disables transmission of a UPC-A number system character.
NOTE
This feature MUST be enabled for IBM interfaces for proper function. 
This item is ignored when the advanced feature, Full Label Edit, is
enabled.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
00D300(CR)
UPC-A Number System Character Transmission =
Disable
00D301(CR)
UPC-A Number System Character Transmission = Enable
DEFAULT