Enter/Exit Programming Mode
Product Reference Guide
157
EAS Deactivation Duration — Retry
Specifies the amount of time EAS deactivation is operative once the function has been
initiated following EAS tag detection (prior to bar code read).
NOTE
This setting pertains only to units configured for EAS Coupled Mode. Refer-
ence the
EAS Mode
description for more information about Coupled and
Decoupled EAS operation. Also reference
EAS Retry Count
.
To set the EAS Deactivation Duration — Retry:
1. Scan the Enter/Exit Programmin
g Mode bar code.
2. Scan the bar code, Set EAS Deactivation Duration — Retry below. You’ll need to
cover any unused bar codes on this and the facing page to
ensure that the scanner reads
only the bar code you intend to scan.
3. Scan the appropriate digits from the Keypad in Appendix C that represent the desired
duration. The selectable range i
s 1-255, which is the duration in 10-millisecond incre-
ments. Pad all single and double digit numbers with leading zeroes t
o yield a three-
digit entry (001-255).
Examples:
005 = 50ms
040 = 400ms
250 = 2,500ms (2.5 seconds)
4. The scanner will automatically exit Programming Mode when the appropriate amount
of digits have been scanned.
Set EAS Deactivation Duration — Retry
DEFAULT
Default setting for this feature is:
050 -500ms
To Next Page
Loading...
Need help?
General
Weight and Dimensions
