Enter/Exit Programming Mode
314
Magellan™ 9800i Scanner
Code 128 Length 1
If Code 128 Length Control is set to Fixed-Length decoding, this feature specifies Code 128
first fixed length. If Code 128 Length Control is set to Variable-Length decoding, this feature
specifies the minmum label length.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the barcode, Set Code 128 Length 1 below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode you
intend to scan.
3. Scan the appropriate digits from the Keypad in Appendix C that represent the desired
label length. The selectable range for this option is 01 to 80. P
ad all single digit numbers
with a leading zero to yield a two-digit entry (01-80).
4. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
Set Code 128 Length 1
DEFAULT
Default setting for this feature = 01
To Next Page
Loading...
