Datalogic Magellan 9800i User Manual

Enter/Exit Programming Mode
Product Reference Guide 159
EAS Pre-Read Time
This feature specifies the time duration that must elapse before reading a label once an EAS
tag is sensed.
To set this feature:
1. Scan the Enter/Exit Programmin
g Mode bar code.
2. Scan the bar code, Set EAS Pre-Read Time below. You’ll need to cover any unused
bar codes on this and the facing page to ensure
that the scanner reads only the bar code
you intend to scan.
3. Scan the appropriate digits from the Keypad in Appendix C that represent the desired
duration. The selectable range is 000-255,
which is the duration in 10-millisecond
increments. Pad all single and double digit numbers with leading zeroes to yield a
three-digit entry (000-255).
Examples:
005 = 50ms
040 = 400ms
250 = 2,500ms (2.5 seconds)
4. The scanner will automatically exit Programming Mode when the appropriate amount
of digits have been scanned.
0582(CR)
Set EAS Pre-Read Time
DEFAULT
Default setting for this feature is:
025 = 250ms

Datalogic Magellan 9800i Specifications

General

Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Power consumption (typical)	12 W
Standard interfaces	RS-232
Connectivity technology	Wired
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Built-in display	No

Weight and Dimensions

Weight	- g