Datalogic Magellan 9800i User Manual

Enter/Exit Programming Mode
154 Magellan™ 9800i Scanner
EAS Retry Count
This feature sets the number of times the deactivation sequence (defined by the feature,
“EAS Deactivation Duration — Retry ”) is restarted after a failed deactivation attempt.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code, Set EAS Retry Count below. You’ll need to cover any unused bar
codes on this and the facing page to ensure that the s
canner reads only the bar code you
intend to scan.
3. Scan the appropriate digits from the Keypad in Appendix C that represent the desired
number. The selectable range is 0-15 resets.
Pad all single and double digit numbers
with leading zeroes to yield a two-digit entry (00-15).
NOTE
A setting of zero specifies no deactivation retries upon failed deactivation
attempt.
4. Complete the programming sequence by scanning the nter/Exit Programming Mode
bar code.
0583(CR)
Set EAS Retry Count
DEFAULT
Default setting for this feature is:
03 - Retry EAS Deactivation three times

Datalogic Magellan 9800i Specifications

General

Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Power consumption (typical)	12 W
Standard interfaces	RS-232
Connectivity technology	Wired
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Built-in display	No

Weight and Dimensions

Weight	- g