Datalogic Magellan 9800i - EAS Good Beep Mode

Enter/Exit Programming Mode
152 Magellan™ 9800i Scanner
EAS Good Beep Mode
This feature sets the mode of operation for the EAS deactivation beep while operating in
coupled mode.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below
. You’ll need to cover any unused bar
codes on this and the facing page to ensure that the scanner reads only the bar code you
intend to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode
bar code.
DEFAULT
058A00(CR)
EAS Good Beep Mode = Disable
058A01(CR)
EAS Good Beep Mode = Beep on Deactivate
058A02(CR)
EAS Good Beep Mode = Beep on Verify