Enter/Exit Programming Mode
294
Magellan™ 9800i Scanner
Code 39 Start Stop Character Transmission
Enables/disables transmission of Code 39 start and stop characters.
NOTE
This item is ignored when the advanced feature, Full Label Edit, is
enabled
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused barcodes
on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
DEFAULT
Code 39 Start Stop Character Transmission = Disable
Code 39 Start Stop Character Transmission = Enable
To Next Page
Loading...
