EasyManuals Logo

Datalogic Magellan 9800i User Manual

Datalogic Magellan 9800i
452 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #125 background imageLoading...
Page #125 background image
Enter/Exit Programming Mode
Product Reference Guide
113
Chapter 9
General Scanner and Scale Features
1D Double Read Timeout
The 1D Double Read Timeout feature specifies the minimum allowable time which must pass
before reading the same 1D label again (e.g. two identical items in succession).
To set the Double Read Timeout:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this
and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar code.
NOTE
DEFAULT
004D1E(CR)
1D Double Read Timeout = 300ms
004D28(CR)
1D Double Read Timeout = 400ms
004D3C(CR)
1D Double Read Timeout = 600ms
004D50(CR)
1D Double Read Timeout = 800ms
If the incidence of multiple reads is not acceptable, increase the Double
Read Timeout setting to a higher value.

Table of Contents

Other manuals for Datalogic Magellan 9800i

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datalogic Magellan 9800i and is the answer not in the manual?

Datalogic Magellan 9800i Specifications

General IconGeneral
TypeBuilt-in bar code reader
Sensor type-
Scanner type1D/2D
Light levels (direct sunlight)0 - 86080 lx
Linear (1D) barcodes supportedGS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supportedAztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage100 - 240 V
Input frequency50 - 60 Hz
Power source typeAC
Power consumption (standby)11 W
Power consumption (typical)12 W
Standard interfacesRS-232
Connectivity technologyWired
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)10 - 40 °C
Operating relative humidity (H-H)5 - 95 %
Product colorBlack, Grey
Built-in displayNo
Weight and Dimensions IconWeight and Dimensions
Weight- g

Related product manuals