Product Reference Guide
49
System Power-Up Recap
The System Power-Up procedure may vary depending upon the requirements of your POS
system. It is generally a good practice to power-down (switch off) all equipment prior to
connecting cables. Check with your System Supervisor and/or refer to your POS terminal
manual for proper power-down and power-up procedures and interface requirements when
connecting any peripheral device.
If you have not identified any specific requirements for your POS system, follow these steps.
1. Power-down the POS terminal.
2. Ensure that power is disconnected from the scanner.
3. Connect the scanner and scale interface cables to your POS terminal. This connection
may use one or two cables depending upon your POS terminal interface.
4. Connect the Remote Display cable if your model is a scanning-scale and make any con-
nections to optional equipment, such as EAS
1
or a handheld scanner.
5. Power-up the scanner or scanning-scale by connecting the power cord to an AC power
outlet. Wait for the unit to complete the Selftest routine (10 seconds maximum).
6. Power-up the POS terminal.
7. Verify that both scanning and weighing data are properly communicated between the
scanner and your POS system. (Weigh, deactivate
2
and scan a few items.) If problems are
encountered, refer to Chapter 4, Problem Isolation.
8. You have now completed installation and system integration of the scanner or scanning-
scale. At this point, the scale must be calibrated and certified in accordance with the
requirements of your state and/or local requirements. Refer to
Chapter 6. Calibration
Procedures for calibration details.
1. Some peripheral equipment must be connected or powered on in a specific order. Check the equipment instructions to verify the
correct sequence.
2. Test EAS deactivation only if applicable for your model.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
