Enter/Exit Programming Mode
330
Magellan™ 9800i Scanner
Codabar Start Stop Character Match
Enables/disables the requirement that start and stop characters match.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused barcodes
on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
DEFAULT
Codabar Start Stop Character Match = Disable
Codabar Start Stop Character Match = Enable
To Next Page
Loading...
