Enter/Exit Programming Mode
244
Magellan™ 9800i Scanner
UPC-E Check Character Transmission
Enables/disables transmission of a UPC-E check character.
NOTE
This item is ignored when the advanced feature, Full Label Edit, is
enabled.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
UPC-E Check Character Transmission = Disable
UPC-E Check Character Transmission = Enable
To Next Page
Loading...
