Enter/Exit Programming Mode
348
Magellan™ 9800i Scanner
MSI Check Character Calculation
Enables/disables calculation and verification of optional MSI check characters.
NOTE
If check character calculation is disabled, the risk is increased that a
misread can occur. When disabled, any check characters in a barcode
are treated as data characters.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused barcodes
on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
MSI Check Character Calculation = Disable
MSI Check Character Calculation = Enable
To Next Page
Loading...
