Datalogic Magellan 9800i - Data Matrix Enable

Enter/Exit Programming Mode
368 Magellan™ 9800i Scanner
Data Matrix Enable
Enables/disables the ability of the scanner to decode Data Matrix labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
010000(CR)
Data Matrix = Disable
010001(CR)
Data Matrix = Enable