Datalogic Magellan 9800i User Manual

Enter/Exit Programming Mode
Product Reference Guide 349
MSI Number of Check Characters
Specifies number of MSI check characters to be calculated and verified.
NOTE
Check characters are always modulus 10.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the barcode below representing the desir
ed number of MSI check characters to be
calculated and verified. You’ll need to cover any unused barcodes on this and the facing
page to ensure that the scanner reads only the barcode you intend to scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
DEFAULT
021700(CR)
MSI Number of Check Characters = 1
021701(CR)
MSI Number of Check Characters = 2

Datalogic Magellan 9800i Specifications

General

Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Power consumption (typical)	12 W
Standard interfaces	RS-232
Connectivity technology	Wired
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Built-in display	No

Weight and Dimensions

Weight	- g