Datalogic Magellan 9800i - Good Read Beep Volume

Enter/Exit Programming Mode
126 Magellan™ 9800i Scanner
Good Read Beep Volume
Selects the beeper volume upon a good read beep. There are five selectable volumes, with each
volume increment adding approximately five decibels to the previous level:
•Low •Medium High
•Medium Low •High
•Medium
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes on this and
the facing page to ensure that the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning t
he Enter/Exit Programming Mode bar code.
001900(CR)
Good Read Beep Volume = Low
001901(CR)
Good Read Beep Volume = Medium Low
001902(CR)
Good Read Beep Volume = Medium
001903(CR)
Good Read Beep Volume = Medium High
DEFAULT
001904(CR)
Good Read Beep Volume = High