Datalogic Magellan 9800i - Micro QR Code Enable

Enter/Exit Programming Mode
382 Magellan™ 9800i Scanner
Micro QR Code Enable
Enables/disables the ability of the scanner to decode Micro QRCode labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
042800(CR)
Micro QR Code = Disable
042801(CR)
Micro QR Code = Enable