Enter/Exit Programming Mode
150
Magellan™ 9800i Scanner
EAS Notification
This feature specifies the output mode and activation of EAS event notification when
operating in Coupled Mode.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below
. You’ll need to cover any unused bar
codes on this and the facing page to ensure that the scanner reads only the bar code you
intend to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode
bar code.
DEFAULT
EAS Notification = Disable
EAS Notification = Notification over POS Port
To Next Page
Loading...
