Datalogic Magellan 9800i - Ignore Host Commands

Enter/Exit Programming Mode
186 Magellan™ 9800i Scanner
RS-232 Ignore Host Commands
When set to ignore host commands, the scanner will ignore all host commands except for the
minimum set necessary to keep the interface active, transmit labels, and transmit scale
information. For normal operation of the interface, disable this feature.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
04F400(CR)
RS-232 Ignore Host Commands = Don’t Ignore
04F401(CR)
RS-232 Ignore Host Commands = Ignore
DEFAULT