Enter/Exit Programming Mode
334
Magellan™ 9800i Scanner
Codabar Correlation
Enables/disables character correlation for Codabar.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused barcodes
on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
DEFAULT
Codabar Correlation = Disable
Codabar Correlation = Enable