Enter/Exit Programming Mode
204
Magellan™ 9800i Scanner
Single Cable RS-232 Use BCC
Enables/disables the ability of the scanner to use BCC (Block Check Character).
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
Single Cable RS-232 Use BCC = Disable
Single Cable RS-232 Use BCC = Enable
To Next Page
Loading...
