Enter/Exit Programming Mode
Product Reference Guide
117
1D Inverse Read Control
This configuration item is used to toggle inverted label reading for 1D bar codes, for example, a
label printed as white on black as opposed to black on white.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this
and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
1D Inverse Read Control = Disable
1D Inverse Read Control = Enable
To Next Page
Loading...
