Datalogic Magellan 9800i User Manual

Enter/Exit Programming Mode
Product Reference Guide 303
Code 39 Stitching
Enables/disables stitching for Code 39 labels. When parts of a Code 39 barcode are presented to
the scanner with this feature enabled, the barcode parts will be assembled by the scanner’s
software, and the data will be decoded if all barcode proofing requirements are met.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the barcodes below. You’ll need to cover any unused barcodes on
this
and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
00D100(CR)
Code 39 Stitching = Disable
00D101(CR)
Code 39 Stitching = Enable
DEFAULT

Datalogic Magellan 9800i Specifications

General

Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Power consumption (typical)	12 W
Standard interfaces	RS-232
Connectivity technology	Wired
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Built-in display	No

Weight and Dimensions

Weight	- g