Enter/Exit Programming Mode
Product Reference Guide
127
Good Read When to Indicate
This feature specifies when the scanner will provide indication (beep and/or flash its green
LEDs) upon successfully reading a bar code.
• Good Read = Indicate after decode
1
• Good Read = Indicate after transmit
• Good Read = Indicate after CTS goes inactive, then active
2
• Good Read = Indicate after each output structure proofed
3
To set the Good Read When to Indicate feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the desired mode bar code from those provided below You’ll need to cover any
unused bar cod
es on facing pages to ensure that the scanner reads only the bar code you
intend to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
Good Read When to Indicate = After Decode
Good Read When to Indicate = After Transmit
Good Read When to Indicate = After CTS goes Inactive,
Then Active
Good Read When to Indicate = After Each Output
Structure Proofed
1. For scanner models having intelligent integrated EAS, label transmission (and hence the good read beep) is completed after the
EAS logic executes.
2. The “Indicate after CTS goes inactive...” mode applies to RS-232 STD and RS-232 WN interfaces only. If set to this mode in other
interfaces, “Indicate after decode” mode will be implemented.
3. When beeping after each output structure decoded, if there are multiple output structures, there is a delay after the beep has fin-
ished. This delay is equal to the Good Read Beep Length.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
