MPC5604B/C Microcontroller Reference Manual, Rev. 8
Freescale Semiconductor 411
An interrupt is generated if the LINIER[BOIE] bit is set.
21.8.1.4 Clock gating
The LINFlex clock can be gated from the Mode Entry module (MC_ME). In UART mode, the LINFlex
controller acknowledges a clock gating request once the data transmission and data reception are
completed, that is, once the Transmit buffer is empty and the Receive buffer is full.
21.8.2 LIN mode
LIN mode comprises four submodes:
• Master mode
• Slave mode
1
• Slave mode with identifier filtering
1
• Slave mode with automatic resynchronization
1
These submodes are described in the following pages.
21.8.2.1 Master mode
In Master mode the application uses the message buffer to handle the LIN messages. Master mode is
selected when the LINCR1[MME] bit is set.
21.8.2.1.1 LIN header transmission
According to the LIN protocol any communication on the LIN bus is triggered by the Master sending a
header. The header is transmitted by the Master task while the data is transmitted by the Slave task of a
node.
To transmit a header with LINFlex the application must set up the identifier, the data field length and
configure the message (direction and checksum type) in the BIDR before requesting the header
transmission by setting LINCR2[HTRQ].
21.8.2.1.2 Data transmission (transceiver as publisher)
When the master node is publisher of the data corresponding to the identifier sent in the header, then the
slave task of the master has to send the data in the Response part of the LIN frame. Therefore, the
application must provide the data to LINFlex before requesting the header transmission. The application
stores the data in the message buffer BDR. According to the data field length, LINFlex transmits the data
and the checksum. The application uses the BDR[CCS] bit to configure the checksum type (classic or
enhanced) for each message.
If the response has been sent successfully, the LINSR[DTF] bit is set. In case of error, the DTF flag is not
set and the corresponding error flag is set in the LINESR (see Section 21.8.2.1.6, Error handling).
1. Only LINFlex0 supports slave mode
To Next Page
Loading...
