MPC5604B/C Microcontroller Reference Manual, Rev. 8
908 Freescale Semiconductor
B.2 Changes between revisions 5 and 7
1
Nexus Development
Interface
Added the “NPC_HNDSHK module” section.
Changed HALT0 to HALT.
Changed STOP0 to STOP.
Changed STANDBY0 to STANDBY.
Replaced the “NDI configuration options” table.
Boot Assist Module Deleted this chapter (relevant content is now represented by the “Microcontroller boot”
chapter).
Enhanced Modular IO
Subsystem
Deleted this chapter (relevant content is now represented by the “Timers” chapter).
System Status and
Configuration Module
Deleted this chapter (relevant content is now represented by the “Microcontroller Boot”
chapter).
Appendix: Register
Protection
Deleted this appendix (relevant content is now represented by the “Register Protection”
chapter).
Appendix: Register
Map
Changed HALT0 to HALT.
Changed STOP0 to STOP.
Changed STANDBY0 to STANDBY.
Extended “Priority Select Register” to INTC_PSR208_210.
Removed CTU_CSR (not implemented on this microcontroller).
Appendix: Revision
History
Changed the format of the revision-history content.
Added a note that Rev. 6 was not publicly released.
1.Rev. 6 was not publicly released.
Table B-2. Changes between revisions 5 and 7
Chapter Description
Throughout Editorial changes and improvements.
Signal Description 100 LQFP pinout and 144 LQFP pinout:
• Removed alternate functions
208 MAPBGA pinout:
• OSC32K_XTAL at R9 changed to XTAL32
• OSC32K_EXTAL at T9 changed to EXTAL32
Clock Description Revised “Progressive clock switching” section.
Added “Progressive clock switching” scheme figure
Update definition of en_pll_sw bit filed on Control Register
Interrupt functionalities are not available on SXOSC
Boot Assist Module Added notes in the following section:
Download 64-bit password and password check
Download data
Execute code
Table B-1. Changes between revisions 7 and 8 (continued)
Chapter Description
To Next Page
Loading...
