Freescale Semiconductor MPC5604B - B.4 Changes between Revisions 2 and 4

MPC5604B/C Microcontroller Reference Manual, Rev. 8
Freescale Semiconductor 911
B.4 Changes between revisions 2 and 4
Analog-to-Digital
Converter
“Threshold Control” Register:
– Removed THRINV field.
Decode Signals Delay Register (DSDR):
– Update the description.
“Max AD_clk frequency and related configuration settings“ table:
– Adeed a footnote.
Safety “SWT_CR” Register:
– Added the field “KEY”.
Real Time Clock /
Autonomous Periodic
Interrupt
“RTCC“ Register:
– Updated the APIVAL description.
Table B-4. Changes between revisions 2 and 4
Chapter Description
Throughout Editorial changes and improvements.
Overview Minor editorial and formatting changes
Updated block diagram
Section 1.2.3, “Chip-level features”: Changed eMIOS-lite to eMIOS
Section 1.4, “Developer support”: Added footnote defining AUTOSAR
Memory map:
– Changed Periodic Interrupt Timer (PIT/RTI) to Periodic Interrupt Timer (PIT)
– Changed CTU-LITE to CTU
– Changed SRAM size from 32 KB to 48 KB
Signal Description Section 2.2, “Package pinouts”: Inverted the order of Figure 2 and Figure 3
208 MAPBGALBGA208 configuration: Changed description for ball H1 from NC to
VSS_HV
Section 2.3, “Pad configuration during reset phases”: Added BAM function ABS[0] to PA[8]
Voltage supply pin descriptions: Added ball H1 to VSS_HV pins
Functional port pin descriptions:
– Added a footnote regarding “I/O Direction” column
– Replaced GPIO[20] with GPI[20]
– Changed GPI[21] to GPIO[21]
– Changed the “Reset config.” of PB[7] and PB[8] to Tristate
– Changed “Pad Type“ from S to M in 27 pads
– Changed pad type from S to M on port pin PE[7]
Table B-3. Changes between revisions 4 and 5 (continued)
Chapter Description