Freescale Semiconductor MPC5604B - 2. Using the I²C module

MPC5604B/C Microcontroller Reference Manual, Rev. 8
Freescale Semiconductor 85
5.3.4.3 Error Configuration (SSCM_ERROR)
The Error Configuration register is a read-write register that controls the error handling of the system.
Table 5-13. SSCM_MEMCONFIG field descriptions
Field Description
PRSZ Code Flash Size
10000 128 KB
10001 256 KB
10010 384 KB
10011 512 KB
PVLB Code Flash Available
This bit identifies whether or not the on-chip code Flash is available in the system memory map. The
Flash may not be accessible due to security limitations, or because there is no Flash in the system.
1 Code Flash is available
0 Code Flash is not available
DTSZ Data Flash Size
0000 No Data Flash
0011 64 KB
DVLD Data Flash Valid
This bit identifies whether or not the on-chip Data Flash is visible in the system memory map. The Flash
may not be accessible due to security limitations, or because there is no Flash in the system.
1 Data Flash is visible
0 Data Flash is not visible
Table 5-14. SSCM_MEMCONFIG allowed register accesses
Access type 8-bit 16-bit 32-bit
Read Allowed Allowed Allowed
(also reads SSCM_STATUS
register)
Write Not allowed Not allowed Not allowed
Offset: 0x06 Access: Read/write
0123456789101112131415
R00000000000000
PAE R AE
W
Reset0000000000000000
Figure 5-15. Error Configuration (SSCM_ERROR)