258 Upgrade and Maintenance Manual RX2540 M4
Expansion cards and backup units
Figure 168: Installing Retimer controller in slot 3
Ê Connect the VPP cable to the connector "CON5" on the Retimer controller
(1).
Ê Install the Retimer controller in slot 3 (see arrow).
Ê Connect the VPP cable to the connector "VPP CPU1" on the system board
(see close-up 2).
Ê Connect the color-coded Oculink cables to the corresponding HDD
backplane, see section "Connecting a 4x 2.5-inch PCIe SSD backplane" on
page 207.
Example configuration with one Retimer controller in slot 9
I To connect the rear PCIe SSD backplane, install the Retimer controller
in slot 9.
To Next Page
Loading...
