RX2540 M4 Upgrade and Maintenance Manual 259
Expansion cards and backup units
Figure 169: Installing Retimer controller in slot 9
Ê Connect the VPP cable to the connector "CON5" on the Retimer controller
(1).
Ê Install the Retimer controller in slot 9 (see arrow).
Ê Connect the VPP cable to the connector "VPP CPU2" on the system board
(2).
Ê Connect the color-coded Oculink cables to the corresponding HDD
backplane, see section "Connecting cables to the rear backplane" on
page 214.
To Next Page
Loading...
