446 Upgrade and Maintenance Manual RX2540 M4
Figure 327: Connecting the front panel cables
Ê Connect the following cables to the system board:
Ê If applicable, connect the ODD cable to the ODD.
Ê If applicable, install the riser module, see section "Riser modules for GPGPU
cards (FL)" on page 82.
Ê Carefully pull the front panel module into its bay and regard that the locking
mechanism snaps in (see circle and figure 328 on page 447 / 329 on
page 447).
V CAUTION!
Ensure that none of the cables are strained or damaged.
I The locking mechanism differs for the installations with LTO drives
because the drive need more place, so that an other locking recess point
is needed.
1 Front panel cable
2 If applicable, front VGA cable
3 Front USB3.0 cable
To Next Page
Loading...
