RX2540 M4 Upgrade and Maintenance Manual 541
System board and components
Ê If applicable, install the iRMC microSD card, see section "Installing the iRMC
microSD card" on page 513
Ê If applicable, install the OCP module, see section "Installing the OCP
module" on page 249.
Ê Install the memory modules, see section "Installing a memory module" on
page 339.
I Ensure that you install each memory module in the slot it was located
before the replacement.
Ê Connect all cables to the system board.
I For the cable plan, see chapter "Appendix B" on page 573.
Ê Install all expansion cards, see section "Installing an expansion card" on
page 253.
I Ensure that you install each card in the slots it was located before the
replacement.
Ê "Installing the fan holder" on page 234
Ê "Installing the air duct" on page 89
Ê "Reassembling" on page 63
Ê Install the PSUs, see section "Installing a hot-plug PSU" on page 128.
Ê "Connecting the power cord" on page 67
Ê Connect all external cables.
Ê "Switching on the server" on page 70
I When the system is powered on after a CPU has been replaced or
upgraded, the Global Error indicator will start flashing with the
message CPU has been changed.
This only indicates that the CPU configuration has been altered.
There is no technical problem.
Proceed as follows:
Ê Restart your server.
Ê As soon as the startup screen appears, press the [F2] function
key to enter the BIOS.
To Next Page
Loading...
